Selecting The Interface Protocol And Setting The Inverter Baud Rate; General; Entering The Access Code - Fronius IG Plus A 3.0-1 UNI Operating Instructions Manual

Selecting the interface protocol and setting the in-
verter baud rate

General

If a data communication connection is required between the inverter and other Fronius
data communication components, the 'Interface protocol' must be set in the 'Basic Service'
menu.
The following 5-digit access code must be entered to access the 'Basic Service' menu:
22742
Entering the ac-
cess code
Press the 'Menu' key
1
'Menu' is shown.
Select the 'Setup' mode using the 'Left'
2
or 'Right' keys
Press the unoccupied 'Menu/Esc' key
3
5 x
'CODE' is displayed, the first digit flashes.
Enter the access code 22742:
4
Use the 'Up' and 'Down' keys to select
a value for the first digit of the access
code
Press the 'Enter' key
5
The second digit flashes.
Repeat steps 4 and 5 for the second,
6
third, fourth and fifth digit of the access
code until ...
81