Section 17: Attaching the Canopy
Parts Needed
• Fuselage
• Canopy
Step 1. Locate the canopy and note the raised lines. You will
need to trial fit the canopy before beginning to trim it.
Step 2. Carefully check the canopy fit to the fuselage
periodically while trimming to make sure not too much material
is removed.
Step 3. Trial fit the canopy to the fuselage
40
Tools and Adhesives Needed
• Scissors
• Canopy glue
• Masking tape
Step 4. After confirming the fit of the canopy, attach it to the
fuselage using canopy glue, such as Pacer Formula 560. Use
masking tape to hold the canopy in place. Allow the glue to dry
at least 24 hours.
Note: After the canopy is set, apply the included trim tape
around the canopy edges for a finished look.