Motorola 3460 Fast’R User Manual page 116

AT Command Set (continued)
Command Option
DA
*
0
n
DB
*
0
1
2
3
DC
*
0
The characters AT or at precede all commands except: +++, #####, and A/
Parameters and options shown shaded gray vary by country. For your country's options,
refer to the 3460 Fast'R Reference Guide (T0022).
Default (pre-set) options are underlined.
B-6
3460 Fast'R
Description
Default Telephone Number to Dial When DTR
108=On
=Off, no default
=Phonebook entry n, where n = 1 to 4, and a telephone
number is stored in n
Receive-Data Buffer Delay
=Disable buffer delay timer
=Enable. Buffer or S-Register 38. Starts the buffer delay
timer immediately upon detection of the disconnect
request. When the timer is operating, the modem
continues to process the transmit or receive buffers. The
modem disconnects when the buffers are empty or the
timer expires, whichever occurs first. Note: When the
modem is set for Direct mode, no data buffering occurs
and the disconnect is immediate.
=Buffer + S-Register 38. Prevents the timer from
starting until either the transmit or receive buffers have
emptied. The modem then disconnects. Once the timer
expires, when the modem is set to Direct mode, data is
not buffered and the timer starts immediately.
=S-Register 38. Allows the timer to start immediately
upon detection of a disconnect request. The request
continues to process either its transmit or receive
buffers. The modem disconnects when the timer expires,
regardless of the buffer states. Note: In Direct mode, no
data buffering occurs. However, the modem delays a
disconnect until the timer expires.
Data Compression
=Disable.
Motorola recommends that you disable data
compression when you use remote configuration at rates
of 9600 BPS and below, because data compression may
produce fractured command responses that may be
difficult to interpret. Although the displayed responses
may be compromised, the configuration function works
properly with or without data compression.