Motorola 3460 Fast’R User Manual page 113

AT Command Set (continued)
Command Option
P
Q
Q0
Q1
Q2
S
Sx=n
T
V
V0
V1
X
X0
X1
X2
X3
X4
The characters AT or at precede all commands except: +++, #####, and A/
Parameters and options shown shaded gray vary by country. For your country's options,
refer to the 3460 Fast'R Reference Guide (T0022).
Default (pre-set) options are underlined.
3460 Fast'R
Description
Select Pulse Dialing
Has same effect as AT
Display Result Code
=Enable. Result codes are displayed on the computer.
=Disable
=Originate. Display result codes only when modem is in
Originate mode.
Store Value in S-Register
Store value n in S-Register x
Select Tone Dialing
Has same effect as AT
Result Code Format
Numeric Code
Text Description
Control Call-Progress Reporting
Determines whether the modem waits for call progress
signals or blind dials when establishing calls.
=Modem uses only NO CARRIER and CONNECT
result codes.
=Modem uses only NO CARRIER, CONNECT, and
CONNECT <Rate> result codes.
=Modem waits for dial tone and uses only NO
CARRIER, CONNECT, CONNECT <Rate> and NO
DIALTONE result codes.
=Modem detects busy signal and uses only NO
CARRIER, CONNECT, CONNECT <Rate>, and
BUSY result codes.
=Modem waits for dial tone and detects busy signal.
Uses only NO CARRIER, CONNECT, CONNECT
<Rate>, BUSY, and NO DIAL TONE result codes.
PT1
*
PT0
*
B-3