Adapt-A-Valve Installation; Reverse Osmosis Module Mounting; Connect The Green And Red Tubing - Watts ZRO-PURE Installation, Operation And Maintenance Manual

Table of Contents

Advertisement

Adapt-a-Valve Installation

Water supply line to the system must be from the cold water supply line only. Hot water
connection is used for rinse water return and must be connected for system to function correctly.
Verify contents prior to installation:
( 2 ) - Plastic Adapt-a-Valve with black collet
( 2 ) - Brass Adapter no washer
( 2 ) - Brass Adapter with black washer
( 2 ) - White rubber washer
*
White
Washer
A
3/8" Configuration
(With Brass Fittings)
* Insert White Washer
WARNING:
Do not use Teflon tape with the Adapt-a-Valve.
Step 10
Turn off the cold and hot water supply to the faucet by turning the angle stop valves completely
off. Open cold and hot water sink faucet to relieve pressure.
Step 11 Choosing the configuration that fits your plumbing, attach the adapt-a-valves as illustrated in
the photos above.
TIPS:
Make sure that the black collet is installed in to the 1/4" opening on the Adapt-a-valve.
Don't forget to install the white compression washer with the 3/8" configuration.
Brass adapter (A) does not need to be tightened with a wrench, only finger tight.

Reverse Osmosis Module Mounting

Step 12
Determine best location for the RO module to be mounted to allow
for future system maintenance. Using the mounting holes on the
bracket, mark the location for the mounting screws on the cabinet
wall under the sink. In the parts bag, locate the two self tapping
screws. Using an electric drill with a Phillips bit, screw them into
the cabinet at the marked location. Hang the module on the screws
using the mounting holes in the bracket

Connect the Green and Red Tubing

Step 13
In the parts bag locate the 1/4" green tubing. Insert one open end of the green 1/4" tube into
the open 1/4" quick connect fitting on the COLD water feed adapta-a-valve making sure the
tube is pushed in all the way to the tube stop. Repeat the procedure to connect red tubing
attached to the RO module to connect to the hot water, return adapt-a-valve.
1/2" Configuration
(Without Brass Fittings)
Page 8
Black
Collet
White
Washer
A
Hot
Cold
Supply
Supply

Advertisement

Table of Contents
loading

Table of Contents