Product Technical & Warranty Information Performance Data Sheet - Watts ZRO-PURE Installation, Operation And Maintenance Manual

Table of Contents

Advertisement

TECHNICAL & WARRANTY INFORMATION
GENERAL USE CONDITIONS:
1. System to be used with municipal or well water sources treated and tested on regular basis to insure bacteriological safe quality. DO NOT use with water that
is microbiologically unsafe or unknown quality without adequate disinfection before and after the system. Systems certified for cyst reduction may be used on
disinfected water that may contain filterable cysts.
2. This system is acceptable for treatment of influent concentrations of no more than 27 mg/L nitrate and 3 mg/L nitrite in combination measured as N and
is certified for nitrite/nitrate reduction only for water supplies with a pressure of 280 kPa (40 psig) or greater. If your water supply is under 40 psi Premier
recommends the use of a RO booster pump for proper operation.
3. Operating Temperature:
4. Operating Water Pressure:
5. pH
6. Maximum Iron present in incoming water supply must be less than 0.2 ppm.
7. Hardness of more than 10 grains per gallon (170 ppm) may reduce RO membrane life expectancy.
8. Recommend TDS (Total Dissolved Solids) not to exceed 1800 ppm.
RECOMMENDED REPLACEMENT PARTS AND CHANGE INTERVALS:
Note: Depending on incoming feed water conditions replacement time frame may vary.
Description
Sediment Pre-filter:
Carbon Pre-filter:
Post Carbon filter
50 GPD R.O. Membrane:
* All Prices Subject to change without notice
Concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving
the system as specified in NSF/ANSI 58. This system has been tested for the treatment of water containing pentavalent arsenic (also known as As (V), As (+5), or
arsenate) at concentrations of 0.30 mg/L or less. This system reduces pentavalent arsenic, but may not remove other forms of arsenic. This system is to be used
on water supplies containing a detectable free chlorine residual at the system inlet or on water supplies that have been demonstrated to contain only pentavalent
arsenic. Treatment with chloramine (combined chlorine) is not sufficient to ensure complete conversion of trivalent arsenic to pentavalent arsenic, Please see the
Arsenic Facts section of the Performance Data Sheet for further information
Avg. In.
(mg/L)
Arsenic (Pentavalent)
Barium Reduction
Cadmium Reduction
Chromium (Hexavalent)
Chromium (Trivalent)
Copper Reduction
Cysts
92,000#/ml
Fluoride Reduction
Lead Reduction
Nitrate
Nitrite
Nitrate + Nitrite
Radium 226/228
25pCi/L
Selenium
TDS
Turbidity
Depending on water chemistry, water temperature, and water pressure Premier's R.O. Systems production and performance will vary.
REFER TO OWNER'S INSTALLATION/SERVICE MANUAL FOR FURTHER MAINTENANCE REQUIREMENTS AND WARRANTY
INFORMATION.
Phone: (480) 675-7995
8716 W Ludlow Drive Suite #1
System conforms to Standard 58 for specific claims
Maximum: 100°F (40.5°C)
Maximum: 85 psi (6.0kg/cm2)
2 to 11
#105311
#105351
#105341
#105331
Avg. Eff.
% Reduction pH
(mg/L)
.310
0.001
9.2
0.08
0.031
0.0004
0.30
0.002
0.30
0.001
3.2
0.02
3 #/ml
8.7
0.19
0.15
0.002
27
3.8
3.1
0.41
30
4.2
5pCi/L
94.85
<0.2
741
22
11.3
0.1
Fax: (623) 866-5666
Watts Premier Inc.
Peoria, AZ 85381
ZRO-Pure
Change time Frame
6 Months
6 Months
12 Months
2 to 5 years
Pressure
99.6%
7.24
50psi
99.0%
7.64
50psi
98.0%
7.49
50psi
99.0%
7.24
50psi
99.0%
7.64
50psi
99.0%
7.40
50psi
99.99%
7.44
50psi
97.0%
7.24
50psi
98.8%
7.39
50psi
86.0%
7.24
50psi
86.0%
7.24
50psi
86.0%
7.24
50psi
80.0%
7.24
50psi
97.0%
7.24
50psi
97.0%
7.28
50psi
99.0%
7.43
50psi
Page 16
Minimum: 40° (4.4°)
Minimum: 40 psi (2.8kg/cm2)
Cost
$ 9.95
$15.95
$15.50
$89.00
Max Eff.
Inf. challenge
mg/L
concentration
mg/L
0.002
0.30±10%
0.12
10.0±10%
0.0008
0.03±10%
0.004
0.03±10%
0.002
0.03±10%
0.04
3.0±10%
18
minimum 50,000/mL
0.3
8.0±10%
0.005
0.15±10%
4.3
27.0 ±10%
0.46
3.0 ±10%
4.8
30.0 ±10%
5pCi/L
25pCiL±10%
<0.2
0.10±10%
26.0
750±40mg/L
0-1
11±1mg/L
Email: wpmail@watts.com
Max Allowable
concentration
mg/L
0.010 mg/L
2.0
0005
0.1
0.1
1.3
N/A
1.5
0.0107
10.0
1.0
10.0
5pCiL
0.05
187
0.5NTU

Advertisement

Table of Contents
loading

Table of Contents