Table of Contents
Advertisement
Faucet Installation
Step 5
Place the escutcheon chrome plate and the
black rubber washer on the faucet shank.
(Parts found in faucet parts bag).
Step 6
Insert the faucet shank through the hole in sink
and let it rest on the sink top.
Step 7
From the underside of the sink, slide on the
locating washer, lock washer and brass
nut onto the shank. Check orientation of
faucet then tighten brass nut securely.
This faucet provides an electronic monitor
that will tell you when it is time to replace
the filters in your water treatment device.
The light indicator on the handle will flash
blue for the life of the filter, turning red
once the life of the filter has been reached.
This can occur after six months of use, or
sooner for heavy water usage. The battery
life is expected to last one year, however,
under heavy use the battery may need
to be replaced sooner. For replacement,
look for battery number CR2032 (Watts
p/n:116080) which should be available at
your local battery store or contact Premier
at 800-752-5582. You may also order online
at www.wattspremier.com.
Connecting to the Faucet
Locate the blue 1/4" tube attached to the RO module labeled
Step 8
"Faucet". Remove a brass nut, plastic sleeve and brass insert from
the parts bag. To assemble, place the brass nut on the blue tube
first, then the sleeve (small tapered end of sleeve must point to the
end of tube) and then push the brass insert all the way into the end
of the tube. (See Picture)
Insert the blue tube into the end of the faucet shank and use a
Step 9
wrench to tighten the brass nut securely.
Page 7
Escutcheon Plate
Rubber Washer
Locating Washer
Lock Washer
Brass Nut
Tube Insert
Ferrule (Sleeve)
Compression Nut
Advertisement
Table of Contents
