Table of Contents
Advertisement
You have completed the installation of your new Reverse Osmosis system.
Start up Instructions
Warning: To prevent the possibility of electrical shock, clean up any water on
cabinet floor and dry all water from outside of RO unit.
Turn on the incoming hot and cold water angle stop valves.
Step 1
Turn both of the adapt-a-valves on and check the system for leaks and tighten fittings
as necessary.
Note:
Check daily over the next week
to ensure no leaks are present.
Step 2
Plug the (24 volt) transformer
power cord connector into the
ESOV as pictured.
Step 3
Plug the transformer into the
electrical outlet under the sink.
Step 4
Ensure ball valve on tank is open.
Step 5
Open the RO faucet and leave it
open until water begins to drip.
Then close the faucet.
The tank will take between 2 - 4
hours to fill.
Note:
If no water comes out of the RO
faucet after a few minutes check
the power outlet! It is possible that the power outlet you used for the RO unit
is controlled by the garbage disposal switch. To test - Unplug the garbage
disposal and flip the garbage disposal switch to "on" . If the RO pump turns on
and water starts to drip out of the RO faucet you will need to connect the system
to a different power outlet socket.
Step 6
After the tank has filled once, open the RO faucet and drain the tank.
Note:
Water may be cloudy or milky due to air in the system and carbon particles flushing out
of the final polishing filter. This condition will resolve itself after flushing a couple of
tanks of water.
Step 7
Complete step #6 two more times. The process of flushing the system first three times
should take about one day to complete. The fourth tank can be used for drinking water.
Note:
Flushing of the tank 3 times is only necessary during the initial startup and after replacing
the membrane.
Congratulations!
Please Follow the Startup Instructions.
Page 11
ESOV
Advertisement
Table of Contents
