Table of Contents
Advertisement
Tank Ball Valve Installation
Teflon tape must be applied in a clockwise direction. Wrap
Step 18
(7 to 12 turns) around the male pipe threads (MPT) on the
stainless steel fitting on top of the tank.
Thread the quick connect ball valve (supplied in the parts bag)
Step 19
onto the stainless steel connector on the tank.
Note: Do not over-tighten plastic connections.
Blue Tube Connection (From The ESOV To TANK)
Position tank in desired location, stand it upright or lay it on its
Step 20
side (using the black plastic stand included). Insert the blue 1/4"
tube from the ESOV into the quick connect fitting on the tank ball
valve. Make sure the tube is pushed in all the way to the tube
stop (see page 9 for quick connect fitting use directions).
Note: Set the blue ball valve knob in-line with the blue tube, this is the "open" position.
Page 10
Advertisement
Table of Contents
