Fuji Xerox D125 Quick Reference Manual page 106

6 Problem Solving
The copy is
misaligned or
skewed.
Part of the image
is missing on the
copy.
6
The copy has a
stripe pattern.
Printing is faint.
(smudged,
unclear)
106
Symptom
Is the document loaded
correctly?
Is the paper loaded correctly
in the tray?
Are the paper guides of
Tray 5 (Bypass) correctly
aligned to the paper?
Are the document guides on
the document feeder set in
the correct positions?
Is the paper tray inserted
correctly?
Is the paper damp?
Is folded or wrinkled paper
included in the tray?
Is the document pasted or
folded?
Is the enlargement ratio too
large?
The paper is damp.
The drum cartridge has
deteriorated or is damaged.
There is no toner left in the
toner cartridge.
Cause
Load the document correctly.
Refer to "Copying" (P.34).
Load the paper correctly.
Refer to "Loading Paper" (P.66).
Load the paper correctly and align the
document guides to the document edges.
Refer to "Loading Paper in Tray 5 (Bypass)"
(P.69).
Load the document correctly, and align the
document guides to the document edges.
Refer to "Copying" (P.34).
Firmly push in the tray until it stops to
insert it properly.
Refer to "Loading Paper" (P.66).
If the paper is damp, the copy image may
be partially missing or unclear. Replace the
paper with a new one.
Refer to "Loading Paper" (P.66).
Remove the unsuitable paper or replace all
of the paper with a new one.
Refer to "Loading Paper" (P.66).
The pasted or folded section may not be
laying flat on the document glass. Place a
stack of white sheets on top of the
document to flatten the document against
the document glass.
Vertical stripes may be printed on the
copies depending on the ratio. Adjust the
ratio to eliminate the stripes.
Refer to "3 Copy" > "Copy" > "Reduce/Enlarge
(Making Enlarged/Reduced Copies)" in the
User Guide.
Replace the paper with a new one.
Refer to "Loading Paper" (P.66).
Contact our Customer Support Center.
Replace the toner cartridge with a new
one.
Refer to "Replacing the Toner Cartridge"
(P.91).
Remedy