Song Mode: The Fx Pages - Kurzweil PC3LE6 Musician's Manual

Time In
The Time In parameter determines the start time for Loop or Punch In recording (more on this
below).
Time Out
The Time Out parameter determines the stop time for Loop or Punch In recording.
Song End
The Song End parameter determines the end point for the song. Note that when Time Out and
Song End are set to the same location, changes made to Song End are reflected in Time Out.
When recording beyond your initially specified Song End point, you'll notice that the Song End
location automatically moves and rounds to the next bar, so as to always be ahead of the
playhead. It is possible to move the Song End point to a location before other MIDI events (i.e.,
in the middle of the current song)—the sequencer will ignore (but not delete) events after this
point.
Loop
With the Loop parameter set to Loop, the sequencer will loop the segment of the song between
Time In and Time Out.
Punch
With the Punch parameter set to Punch, the sequencer (in RECORDING mode) will record
events only between Time In and Time Out.
Metro
The Metro parameter determines the recording modes in which the metronome will play. With
Metro set to Rec, the metronome only plays while recording is in progress. With Metro set to
Always, the metronome plays during playback and recording. With Metro set to Off, the
metronome doesn't play at all.

Song Mode: The FX Pages

The three Song mode FX pages—FX, AUXFX1, and AUXFX2—work the same way as the effects
pages in Setup Mode. See the Setup mode chapter effects section: The FX Pages: FX, AUXFX1,
AUXFX2 on page 7-60 for information on using these pages.
Song Mode and the Song Editor
Song Mode: The FX Pages
10-11