Assigning A Single Knob To Crossfade Between The Volume Of Different Zones - Kurzweil PC3LE6 Musician's Manual

Assigning A Single Knob to Crossfade Between The
Volume Of Different Zones
You can assign a Knob to crossfade between sounds on different Zones. Crossfading allows you
to smoothly blend between two sounds by increasing the volume of one Zone as the volume of
the other Zone is decreased. For example, let's edit the setup 8 Piano & Pad. The setup 8 Piano &
Pad is a layered setup that uses piano on Zone 1 and "pad" type synth sounds on Zones 2 and 3. Let's
assign a single Knob to crossfade between Zones 2 and 3. This will allow us to hear either the piano and
one of the pads, or the piano and a blend of both pads.
1.
2.
3.

Assigning A Single Knob to Crossfade Between The Volume Of Different Zones

If you are not already in Setup mode, press the Exit button until you reach the ProgramMode page,
then press the Setup mode button, located with the mode buttons to the left of the display. This
will bring you to the Setup mode main page. Next, press 8 and then Enter on the alphanumeric pad
to select the setup 8 Piano & Pad (see below.) You can also select setups by using the - / + buttons
or Alpha Wheel.
With the setup 8 Piano & Pad selected in setup mode, press the Edit button on the front panel.
This will bring you to the CH/PROG page of the setup editor (see below.)
Step 3
From the CH/PROG page, press the CTRLS soft button on the bottom of the screen (see above.)
This brings you to the Controllers page where you can view and assign physical controllers to
destinations for the current Zone.
Tutorials: Setup Mode
13-25