Important Points For Mounting And Mounting Place - Baymak Linyitomat Plus Instructions And Operating Manual

Important Points for Mounting and Mounting Place

63 9810.0293 - Rev.00 - 08/09/2008
Caution! Safety valve and air release line must
be open everytime because of water discharge for
safety. Safety valve must be checked occasionally.
Safety valve must be installed onto boiler directly and
there must not be any other valve or equipment. All used
equipment must be in accordance with CE standards.
Electricshock Danger! Before protective hat and
pieces of cover are taken out, all electrical connections
on boiler must be disassembled. Works that will be done
when electric is on, must be carried on by authorized
people after all necessary precuations are supplied.
Please read this manual before using the boiler.
Start-up must be done by authorized service
station. Otherwise the boiler will be out of warranty.
The appliance shall be installed on floors with an
adequate load-bearing
construction doesn't meet this prerequisite, suitable
measures (e.g. load distributing plate) shall be taken to
achieve it.
The installation of the appliance need to provide
access for cleaning the appliance, the flue gas
connector and the chimney flue.
Caution! Subjects refering considerations during
mountings related with operations of heating or a tank
are below.
To prevent from water damages that will occure
due to especially water leakages in tank, convenable
precuations must be taken for mounting. Drain lines and
safety system must be suitable and checked periodically
during first start-up and operation.
Ambient where is boiler in must be dry and must
not frost (between 0° and 45°).
Operations about supplying required air to burn
the boiler and discharging waste gas must be in
accordance with CE standards and local distrubition
companies that is responsible from that region.
Place the boiler to a boiler room.
Do not place the boiler to your bedroom!
9
capacity. If an existing