Protection Against Corrosion; Demands Related With Heating System Water - Baymak Linyitomat Plus Instructions And Operating Manual

Bypass valve
(It is closed in normal situation, it
should be opened in case of power
cut.)
Circulating
pump

Protection against corrosion

Demands related with heating system water

63 9810.0293 - Rev.00 - 08/09/2008
There must be absolutely a bypass line on the
inlet pipe of the boiler. In case of the power cut,
you can secure the safety of the boiler and
installation.
Physical life of the boiler is 10 years according to
related laws. This period contains service and providing
required spare part duration for executing the functions.
The boiler was produced in accordance with
EN 303-5.
Caution! Combustion air must not contain
elements that will cause to corrosion. As an example,
these gases are water steams of solution and cleaning
substances or gases in spray boxes.
To prevent the damages occured as a result of
corrosion in installation, quality of heating water must be
as good as drinking water. Unsuitable waters containing
chemical additive substances or causing to corrosion
must not be used.
Filling water for boiler and installation should not
contain residues, contaminates and unwanted solid
materials. These
dangerous for the boiler and installation. If you have any
doubt about the water pureness, you should mount a
fitler on inlet of the filling valve.
The degrees of water hardness must not be
bigger than 20º F'den ( 1º F = Calsium carbonade @ 1 lt
water) . ( Hard water ) If the degres of water hardness is
bigger than 20º F, a water softening system absolutely
must be used.
14
unwanted materials are very