Table of Contents
Advertisement
LINYITOMAT PLUS BOILER BURNING INSTRUCTION
• Burning method changes according to size of coal. Coal quality and the
characteristics of the burning, affect to the burning method and efficiency of
the boiler
• Normal sized coals (Orange size), For first burning, fill some wood and
wood part and ignite from lover side. This time the fan should be closed
position and the ash cleaning door should be fully open, the other doors
should be closed. After igniting, the ash cleaning door should be closed and
loading door opened, 1/3 capacity of coal per excreted in the boiler (The
average 5-20kg). After coal loading process, the fan can be on position. In
this position even the fan off, burning can be started but it's depending to the
coal quality.
• You can choose the burning methods at above, according to the coal quality
and statement of combustion.
• Loaded 1/3 capacity coal start to burning and begin to charcoals, the ash
cleaning door to be opened and skewered and than to be made last loading.
• For the last loading, completely fill the boiler. During the burning, open the
the ash cleaning door and skewer to the coal every 2-3 hour. Also open the
coal loading door and reverse sunburned coal parts using a rabble. During
the coal loading process to be sure if ON/OFF switch at OFF position. If it is
not, turn it OFF
• It is important that fan's electrical connections to be done right, otherwise the
fan doesn't work correctly and doesn't give enough air into combustion
chamber.
• Load the boiler with coal before the coal completely burn. (When the coals
become completely charcoals) Operating the boiler in this way is more
economic and more efficient.
• In the mornings, the ash cleaning door to be opened and skewered. After
starting of the burning can be loaded coal. Before this process, the fan may
be made Switch On.
• If coal loading was not enough in the previous evening or in the day coal
level gets low, load some wood and after getting enough burning and load
the enough coal. Otherwise if the coal loaded on the some sunburned coal,
it causes to be flame turned off.
• The boiler should be cleaned at list once a week. Burning efficiency will get
higher when used cleaned boiler.
Don't use cokes.
•
• Powder coal, and a very small with granular coal, For the first burning,
fill to much wood and wood part and ignite them. (the ash cleaning door
should be open).
• When the flame is grove enough, load 5-10 kg coal on the woods. Until coal
and wood turn into charcoals, you should wait.
63 9810.0293 - Rev.00 - 08/09/2008
22
Advertisement
Table of Contents
