Ping To Defaults - Alcatel SPEED TOUCH PRO User Manual

16.2.2

Ping to Defaults

Introduction
Procedure
Note
3EC 17059 ABAA TCZZA Ed. 01
A second software method to reset all settings to the original
defaults is the Ping to Defaults .
The technique is identical to that used for the Ping of Life , except
that another MAC address is used, i.e. 01–90–D0–80–01–FF.
Proceed as follows:
1. Turn off the STPro.
2. Open a command line (DOS) window (Windows OS), or a
terminal window (UNIX, Linux) on a PC.
3. Add a static entry to the ARP cache, according to following
syntax:
arp –s <any IP address> 01–90–D0–80–01–FF
<any IP address> can be any address within your subnet
as long as it is not used by any other member of your local
network.
4. To verify whether this step was successful execute arp –a
5. Initiate a continuous pinging, by executing following
command:
ping –t <any IP address>
6. Turn on the STPro.
7. After the STPro finished its POST, it will perform a reset to
default settings.
8. You must clear the entry in the ARP cache by issuing
the following command:
arp –d <any IP address>
9. If needed, reconfigure the STPro IP address, e.g. via a
Ping of Life .
The used
<any IP address>
assimilated by your STPro. The STPro will restart with the original
defaults, including the default IP address 10.0.0.38.
16 Maintenance - Speed Touch To Defaults
to perform a Ping to Defaults is not
191 / 238