Alcatel SPEED TOUCH PRO User Manual page 108

10 Configuration and Use - CIP & IP Routing
Remote premisses
configuration
Routing configuration
Note
108 / 238
At the remote DSL side, the CIP LIS is terminated by the remote
access router (2) and IP packets are forwarded to local servers, or
the Internet and vice versa.
Here, the CIP member is configured with IP address 172.16.1.2
and is part of the same LIS 172.16.1.x.
Additionally, a VC, with the same VPI/VCI values 8/80, is assigned
to this CIP member (e.g. implicit assignment, because STPro(1) is
RFC1577/RFC2225 compliant).
The routing engine must be configured with routes to the final
destinations.
For the given example, the configuration is as follows:
STPro(1) has its default route pointing to the remote access
"
router (2)
The local PCs of IP network 10.0.0.x have default gateways
pointing to STPro(1)
The remote access router (2) has a route for Net10"
"
(10.0.0.0) pointing to STPro(1)
The remote IP network 192.168.0.x has a default gateway
pointing to access router (2).
You will notice that the example relies exclusively on Private IP
addresses. Depending the application though, other IP addresses
in combination with NA(P)T (configurable via the CLI) can be
used.
3EC 17059 ABAA TCZZA Ed. 01