Transparent Bridging - Alcatel SPEED TOUCH PRO User Manual

12 Networking Services - IP
12.2.1

Transparent Bridging

IP vs. Bridging
Typical Bridging Setup
Using TCP/IP and
Bridging
Local IP
communication
CAUTION
136 / 238
Basically, Bridging does not require any IP address at all: neither
in your PC(s), nor in your STPro.
However, in case of Internet access, private IP networking or in
case the Bridging packet service is used for Bridged PPPoE, your
PC(s) must be configured for TCP/IP .
In most cases, your SP will require you to use DHCP for your PC.
In this case the DHCP server is at the remote side of the DSL
connection. Therefore, your STPro's DHCP server must be
disabled.
Your SP may:
Provide you with an IP address
"
Require you to use DHCP .
"
Alternatively, a second but Private IP address can be manually
configured for local IP communication. It depends on your OS
whether it supports this combination.
e.g. Microsoft supports Logical Multihoming via Registry keys.
Bridging & DHCP Service
The STPro DHCP server is by default enabled (via Auto DHCP).
In case you use your STPro in Bridging mode and your ISP
requires you to enable DHCP in your PC(s), you must disable the
DHCP server inside the STPro to avoid conflicts between two
DHCP servers being active at the same time.
Setting the DHCP modes of your STPro is described in section
12.4.
3EC 17059 ABAA TCZZA Ed. 01