Setting The Heating - DeDietrich NeOvo EcoNox EFU 22 User Manual

Fig.39 Displaying the User menu
Fig.40 Accessing the heating parameters
Fig.41 Confirming the heating circuit
MW-3000249-2
7615193 - v01 - 09072015
2. Select the desired parameter by pressing
the list of parameters that can be adjusted.
3. Confirm the selection by pressing
4. Modify the value of the parameter by pressing
5. Confirm the new value of the parameter by pressing
6. Go back to the main display by pressing
For more information, see
Browsing in the menus, page 19
User menu, page 27
MW-5000040-3

8.2.2 Setting the heating

Note
The name of the PCB is displayed. Check that it is actually the
PCB on which the setting must be made.
1. Access the heating shut-down pressing the
Note
If no outside temperature sensor is connected, this menu can be
used to set the temperature of the heating water.
If an outside temperature sensor is connected, this menu can be
used to set the set point.
MW-5000144-1
2. Display the parameters for the desired circuit by pressing the
The name of the circuit and the heating water temperature set point
are displayed alternately.
3. Access setting of the heating water temperature set point by press­
ing the
4. Set the heating water temperature set point by pressing
5. Confirm the new temperature set point by pressing the
Note
Press the
key. Confirm by pressing the
key.
key to cancel all input.

8 Control panel settings IniControl 2
or to scroll through
.
or .
.
.

key twice.
key.
or
key.
EFU
or
key.
31