b. Turn the engine switch to "ON" position, and loosen the carburetor float bowl drain screw to discharge
from inside of carburetor float bowl.
HY1000Si
c. Take off the spark plug cap, pull the recoil starter grip three or four times, discharge the petrol from
the fuel pump and fuel lines.
d. Turn the engine switch to "OFF" position, and tighten the drain screw of carburetor.
e. Reinstall the spark plug cap.
HY1000Si
9.3 Change the engine oil.
9.4 Remove the spark plug, and pour a tablespoon of clean engine oil (10~20ml) into the
cylinder. Revolve the engine several times to distribute the oil, and reinstall the spark plug.
9.5 Pull the starter grip slowly until you feel resistance. At this point, the piston is coming up on
its compression stroke and both the intake and exhaust valves are closed. In this position, it
helps to protect the engine from internal corrosion.
SCREW DRIVER
STARTER GRIP
PAGE 26
HY2000Si
STARTER GRIP
HY2000Si