Yunca Gas jervois Operation, Maintenance And Warranty Manual page 13

CLEANING UNDER THE TOP AND LOUVRES
Two screws at the back and two lugs at the front hold the top panel in place. Remove the screws. Lift
the top up and slide forward to disengage the front lugs. Move the top to allow the access to clean.
Note: If a flue guard kit has been fitted this will need to be removed at this stage. This is done by
sliding the front half up and out and unscrewing the back half from its brackets.
INSPECTING THE VENTING
An inspection of the venting system should be made during the annual service appointment. There
must be no blockages and the flue must be in good repair. Any sections that are taken apart for
inspection must be reassembled and sealed as required.
CLEANING THE FAN FILTER
This is the one maintenance procedure designed to be carried out by the householder.
It can be cleaned with a brush or vacuum cleaner, and replaced.
19-07-05 Page 13 of 20 Operation Instructions for Jervois Freestanding Gas Heater March 2002