Yunca Gas jervois Operation, Maintenance And Warranty Manual page 12

REPLACING THE GASKET.
The YUNCA Jervois has a 10mm fibreglass gasket surrounding the front door. Should it ever need
replacement, use only the replacement gasket that is available from your YUNCA dealer.
Procedure.
1. Remove the front door as described on previous page.
2. Remove the existing gasket and clean the channel of all loose material.
3. Lay the gasket in the channel ensuring the gasket is not stretched.
4. Replace the door carefully to avoid dislodging the gasket.
Cleaning The Glass
The glass may be cleaned with ordinary household glass cleaner and a soft cloth or paper towel.
Note: Never clean the glass when it is hot. Do not use abrasive cleaners on the glass.
CLEANING THE LOG SET AND FIREBOX.
During the annual inspection and maintenance appointment, the service person should clean dust, lint
and any light soot accumulation from the logs and the fire box area. An extra soft brush should be
used on the logs as they are extremely fragile. If at any time the logs cannot be removed or installed
without force, the cause must be found. The logs must never be forced.
Procedure,
1. Remove front door as described on page 11.
2. Remove the complete log set from the firebox by lifting it up and out. Brush it gently over a
newspaper and carefully place it out of the way.
3. The bark tray can be removed by undoing the attachment screws and lifting out.
4. With firebox empty, a vacuum cleaner can be used to remove any visible dust and lint from within
the firebox area.
5. Replace the bark tray.
6. Replace log set.
8. Replace the front door.
19-07-05 Page 12 of 20 Operation Instructions for Jervois Freestanding Gas Heater March 2002