Cycle And Run Hours Monitoring; Setpoint Configuration; Setting The Central Heat Setpoint; Reviewing Status Detail - FULTON Reliance 500 Installation And Operation Manual

OPERATION
!
WARNING
Non-Fulton product information is for
reference purposes only. No Fulton
document should substitute for full
review of documentation available
from the component manufacturer.
4
CAUTION
Only factory-trained personnel should
attempt to alter password protected
Control preset values.
3-8

Cycle and Run Hours Monitoring

Burner cycles, burner run time, and pump cycles can be viewed from the
Statistics Con guration screen on the Control. See Figure 14.
FIGURE 13 MAIN/HOME SCREEN
FIGURE 14 CYCLE AND RUN HOURS MONITORING
Setpoint Confi guration
Refer to Figure 15 for Setpoint Con guration data.

Setting the Central Heat Setpoint

Refer to Figures 15 -17 for CH Con guration and Operation details.

Reviewing Status Detail

Refer to Figure 18 for ame signal status detail.
SECTION 3
RLN-IOM-2012-1205
© The Fulton Companies 2012