S Tep 3: P Ower O N P; Tep Ower Egasus - Promise Technology Pegasus 2 R4 Installation Manual

s 3: p o
tep oWer
Follow these steps to connect the power cord and power on the Pegasus2.
1. Attach the power cord on the back of the Pegasus2 unit. (See page 4 to see an
illustration of the back of device)
2. Plug the other end into a power source.
3. Press the Power Button. (See illustration of front of device below).
You will observes the that the Power Button LED turns orange.
It takes about 30 seconds to boot the Pegasus2 unit. When fully booted:
• The Power Button LED turns blue.
• The drive carrier Power / Status LEDs turn blue.
Pegasus2 boot up LED behavior
Power
Button / LED
p 2
n egAsus
7
Promise Technologies
Drive Power /
Status LED