Panasonic LUMIX DMC-ZS100 Owner's Manual page 55

Enabling/disabling the histogram display
→ [Custom] → [Histogram] → [ON] / [OFF]
When set to [ON], you can move the display position of the histogram by pressing
• Direct touch operation is also possible from the recording screen.
Displays distribution of brightness in picture – e.g.
if the graph peaks at the right, this means there are
several bright areas in the picture. A peak in the center
represents correct brightness (correct exposure). This
can be used as a reference for exposure correction, etc.
●
When the histogram is not the same as that of the recorded picture under the following
conditions, histogram will be displayed in orange:
• When manual exposure assist indicates settings other than [
or during Exposure Compensation.
• When the flash fires.
• When the correct exposure is not achieved or when the brightness of the screen cannot be
displayed accurately in a dark location.
●
The histogram is different from those displayed using the image editing software of a computer.
Enabling/disabling the guideline display
→ [Custom] → [Guide Line] → [
• The guideline is not displayed during panorama picture recording.
When you select [
• You can also set the position directly by touching [
screen.
55
], you can move the position of the guideline by pressing
Buttons/Dials/Levers Used for Recording
Dark ← OK → Bright
] in Manual Exposure Mode
] / [ ] / [ ] / [OFF]
] on the guideline of the recording
Basics
.
(Example)
.
SQW0547