Valor L2 SERIES Installation & Owner's Manual page 7

applied to the surface, no alcohol/solvent based clean-
ing agents nor polishes should be used. Dry stains can
be removed using a white or light colored cloth with mild
soap and warm water when the material is cool, then
dried immediately. If the stain is hard to remove, use a
white or light colored synthetic scrub pad (not steel wool)
and dry immediately. In case of an accidental spill, soak
up the liquid IMMEDIATELY with a dry cloth and follow
up with a wipe down with a wet cloth.
Clean the barrier screen dusting it with a soft brush.
Clean the fi rebox ceramic logs/rocks and walls dust-
ing them with a soft brush. Dust can also be removed
from the burner using a soft brush after removing the
ceramic logs. When cleaning, make sure that no par-
ticles are brushed into the slots of the burner.
WARNING
!
CHOKING HAZARD! Ensure that the fi replace
area is clear of fi re glass, vermiculite or shale
particles as these could be ingested by small
children. Vacuum thoroughly around the fi replace
area after cleaning.
To refi t the window:
1. Place the window in its bottom railing. Ensure to
remove any vermiculite or glass particles in
the railing before installing the window.
2. Push the top of the window frame against the
fi rebox.
Bottom railing
Owner's Information
Window frame
2
1
3. While you hold it, pull and hook the side levers back
to the window brackets on each side.
3
DANGER
!
To ensure a safe operation, verify that the levers
are hooked properly to the window tabs; then,
pull out the top of the window and release it to
insure the springs return it.
Also, double-check that the bottom of the
window frame is correctly installed in its the
bottom railing.
Failure to install window correctly can damage
components, cause overheating resulting in
dangerous conditions. Damage caused by
incorrect window installation is not covered
by the Valor warranty.
4. Apply light hand pressure against the window frame
sides to bed-in the window seal.
5. If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and
the frame as indicated.
Hot Glass Warning Plate
WARNING
!
FOR SAFETY PURPOSE, ensure the barrier
screen is re-installed on the fireplace front
after maintenance.
OWNER'S
INFORMATION
7