Locating Lighting, Operation And Rating Information Card; Using Handset Wall Holder; Servicing Your Fireplace; Operating Your Fireplace - Valor 1500IN (NG) Installation & Owner's Manual

1. Remove the barrier screen, the side doors and the
plinth. Grab the battery box and pull it out from its
location. Do not pull the box out by the wire!
Remove side doors
2. Disconnect the battery box.
3. Remove the
screw and
slide the
cover off.
4. Replace the batteries with 4 AA alkaline batteries
orienting them as indicated inside the holder.
5. Replace the cover and screw in place.
6. Reconnect the battery box.
7. Put the battery box back in its position.
8. Reinstall the plinth, side doors and barrier screen.
Locating Lighting, Operation and
Rating Information Card
WARNING
!
DO NOT ATTEMPT TO TOUCH THE DATA CARD
WHILE THE FIREPLACE IS STILL HOT! Let the
fi replace cool fi rst before touching it.
The Lighting, Operation and Rating information is locat-
ed on a card at the right hand side of the fi replace open-
ing. The card is rolled and attached under the plinth.
Window
The info card is located behind the front
panel below the window.
To access the card, remove the barrier screen, side
doors and the plinth. Grab the rolled card and pull it out
of its clip. There is important information on both sides
of the card.
Owner's Information
Remove plinth
Info
card

Using Handset Wall Holder

Your fi replace equipment includes a wall
holder to store the handset. If it hasn't be
installed, refer to the instructions further
on in this manual for the installation.

Servicing Your Fireplace

If any attention is required for your appliance, contact
your supplier quoting the model number. It will be
helpful if the appliance's serial number can also
be quoted. This number is on the rating plate. The
replacement parts are shown at the end of this manual.
Please always quote the part number and description
when requesting spare parts.

Operating Your Fireplace

There are two ways to control your fi replace.
1. Thermostatic Remote Control;
2. Wall Switch.
Thermostatic
Remote Control
The Thermostatic Remote Control can be programmed
to function automatically—see pages 11–15.
The Wall Switch can be used to turn on, off and to
increase or decrease the fl ame height—see page 16.
OWNER'S
INFORMATION
Wall Switch
9