Table of Contents
Advertisement
To replace the batteries:
The battery compartment is located next to the wall
switch in the vicinity of the fi replace. Its front plate is
attached with magnets to the wall switch box.
Fireplace
The battery holder is located beside the wall switch.
1. Pull on the plate next to the
wall switch to access the
batteries.
2. Disconnect the snap
connector from the battery
holder. Do not pull the
connector by the wire!
3. Replace the batteries with 4
AA alkaline batteries orienting
them as indicated inside the
holder.
4. Reconnect the snap
connector to the battery
holder.
5. Put the battery holder back
in its place beside the wall
switch and snap it in place.
Locating Lighting, Operation and
Rating Information Card
WARNING
!
DO NOT ATTEMPT TO TOUCH THE INFORMA-
TION CARD WHILE THE FIREPLACE IS STILL
HOT! Let the fi replace cool fi rst before touching it.
The Lighting, Operation and Rating information is
located on a card at the right hand side of the fi replace
opening. The card is attached under the plinth.
Window
The info card is located behind the front
panel below the window.
Owner's Information
Battery holder
& wall switch
Disconnect
connector
Info
card
To access the card, remove the barrier screen, side
doors and the plinth. Grab the card and pull it out. There
is important information on both sides of the card.
Servicing Your Fireplace
If any attention is required for your appliance, contact
your supplier quoting the model number. It will be
helpful if the appliance's serial number can also
be quoted. This number is on the rating plate. The
replacement parts are shown at the end of this manual.
Please always quote the part number and description
when requesting spare parts.
Operating Your Fireplace
Your fi replace is controlled by the Wall Switch.
The Wall Switch controls your
fi replace. You can turn the pilot on or
off and you can increase or decrease
the fl ame height.
Note that there is no thermostatic
and programming functions with the
wall switch.
TO TURN APPLIANCE ON and OFF
• Press ON-OFF button once to light
pilot. Press again to shut of pilot.
TO ADJUST FLAME HEIGHT
• Press and hold large fl ame
button to gradually increase
fl ame height.
• Press and hold small fl ame
button to gradually decrease
fl ame height.
OWNER'S
INFORMATION
9
Advertisement
Table of Contents
