Clear Memory Mode - Subaru Forester 2004 Service Manual

9. Clear Memory Mode

A: OPERATION
1. WITHOUT SUBARU SELECT MONITOR
1) After calling up a DTC, gripped the diagnosis
connector terminal 6 from ground terminal.
2) Repeat 3 times within approx. 12 seconds; connecting and disconnecting terminal 6 and ground terminal
for at least 0.2 seconds each time.
(3)
(4)
(1) Diagnostic trouble code (DTC)
indication mode
(2) Clear memory mode
(3) ABS warning light
NOTE:
After the diagnostics is completed, make sure to clear memory. Make sure only start code (11) is shown after
memory is cleared.
2. WITH SUBARU SELECT MONITOR
Refer to "Subaru Select Monitor" for information about how to clear DTC. <Ref. to ABS-18, Subaru Select
Monitor.>
Clear Memory Mode
(1)
(5)
(4) Terminal 8
(5) GND (Low level)
(6) 0.2 sec. or more
(7) 12 sec. or less
(3)
(1) Diagnosis connector
(2) Ground terminal
(3) Terminal 3
(4) Terminal 6
(2)
(6) (6)
(7)
ABS-23
ABS (DIAGNOSTIC)
(1)
(2)
(4)
(9)
(8)
(8) 1.5 sec.
(9) GND open (High level)
ABS00115
ABS00402