Subaru Forester 2004 Service Manual page 134

Diagnostics Procedure with Diagnostic Trouble Code (DTC)
Step
1 CHECK GROUND CIRCUIT OF ABSCM&H/U.
1) Turn the ignition switch to OFF.
2) Disconnect the connector from ABSCM&
H/U.
3) Measure the resistance between
ABSCM&H/U and chassis ground.
Connector & terminal
LHD: (B301) No. 23 — Chassis ground:
RHD: (F49) No. 23 — Chassis ground:
2 CHECK POOR CONTACT IN CONNECTORS. Is there poor contact in con-
3 CHECK SOURCES OF SIGNAL NOISE.
4 CHECK SOURCES OF SIGNAL NOISE.
5 CHECK ABSCM&H/U.
1) Turn the ignition switch to OFF.
2) Connect all connectors.
3) Erase the memory.
4) Perform the inspection mode.
5) Read out the DTC.
6 CHECK ANY OTHER DIAGNOSTIC TROU-
BLE CODES (DTCs) APPEARANCE.
Check
Is the resistance less than 0.5
Ω?
nectors among battery, igni-
tion switch and ABSCM&H/U?
Is the car telephone or wireless
transmitter properly installed?
Are noise sources (such as an
antenna) installed near the
sensor harness?
Is the same DTC as in current
diagnosis still being output?
Are other DTCs being output? Proceed with the
ABS-133
ABS (DIAGNOSTIC)
Yes
Go to step 2. Repair the
ABSCM&H/U
ground harness.
Repair the con- Go to step 3.
nector.
Go to step 4. Properly install the
car telephone or
wireless transmit-
ter.
Install the noise Go to step 5.
sources apart from
sensor harness.
Replace the Go to step 6.
ABSCM only.
<Ref. to ABS-8,
ABSCM (ABS
CONTROL MOD-
ULE), REPLACE,
ABS Control Mod-
ule and Hydraulic
Control Unit
(ABSCM&H/U).>
A temporary poor
diagnosis corre- contact.
sponding to DTC.
No