Clear Memory Mode - Subaru Forester 2004 Service Manual

Display screen
The most recent DTC appears on Sub-
Latest
aru Select Monitor display.
The second most recent DTC appears
Old
on Subaru Select Monitor display.
The third most recent DTC appears on
Older
Subaru Select Monitor display.
DTC issued after elapse of a specified
Reference
period of time.
2. READ CURRENT DATA
1) On the «Main Menu» display screen, select the {Each System Check} and press [YES] key.
2) On the «System Selection Menu» display screen, select the {Brake Control System} and press [YES] key.
3) Press the [YES] key after displayed the information of ABS type.
4) On the «Brake Control Diagnosis» display screen, select the {Current Data Display & Save} and press
[YES] key.
5) On the «Data Display Menu» display screen, select the {Data Display} and press [YES] key.
6) Using the scroll key, move the display screen up or down until necessary data is shown.
• A list of the support data is shown in the following table.
Display screen
FR Wheel Speed
FL Wheel Speed
RR Wheel Speed
RL Wheel Speed
Stop Light Switch
Stop Light Switch
G Sensor Output Signal
Valve Relay Signal
Motor Relay Signal
ABS Signal to TCM
ABS Warning Light
EBD Warning Light
Motor Relay Monitor
Valve Relay Monitor
CCM Signal
NOTE:
For detailed operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".

3. CLEAR MEMORY MODE

1) On the «Main Menu» display screen, select the
{Each System Check} and press [YES] key.
2) On the «System Select Menu» display screen,
select the {Brake Control System} and press [YES]
key.
3) Press the [YES] key after displayed the informa-
tion of engine type.
Subaru Select Monitor
Contents to be monitored
Contents to be monitored
Wheel speed detected by front ABS wheel speed sensor RH is dis-
played
Wheel speed detected by front ABS wheel speed sensor LH is dis-
played
Wheel speed detected by rear ABS wheel speed sensor RH is dis-
played
Wheel speed detected by rear ABS wheel speed sensor LH is dis-
played
Stop light switch signal
Stop light switch monitor voltage is displayed.
Voltage equivalent to vehicle acceleration detected by analog G
sensor is displayed.
Valve Relay Signal
Motor Relay Signal
ABS operation signal from ABS control module to TCM
ON operation of ABS warning light is displayed.
ON operation of EBD warning light is displayed.
Operating condition of motor relay is displayed.
Operating condition of the valve relay is displayed.
ABS operation signal from ABS control module to TCM
4) On the «Brake Control Diagnosis» display
screen, select the {Clear Memory} and press [YES]
key.
Display
Clear memory?
ABS-19
ABS (DIAGNOSTIC)
Unit of measure
km/h or MPH
km/h or MPH
km/h or MPH
km/h or MPH
ON or OFF
V
V
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
Contents to be monitored
Function of clearing DTC.