Subaru Select Monitor - Subaru Forester 2004 Service Manual

ABS (DIAGNOSTIC)

6. Subaru Select Monitor

A: OPERATION
1. READ DIAGNOSTIC TROUBLE CODE
(DTC)
1) Prepare the Subaru Select Monitor kit. <Ref. to
ABS-11, SPECIAL TOOL, PREPARATION TOOL,
General Description.>
2) Connect the diagnosis cable to Subaru Select
Monitor.
3) Insert the cartridge into Subaru Select Monitor.
<Ref. to ABS-11, SPECIAL TOOL, PREPARA-
TION TOOL, General Description.>
4) Connect the Subaru Select Monitor to data link
connector.
(1) Data link connector is located in the lower
portion of the instrument panel (on the driver's
side).
(1)
(1) Data link connector
Subaru Select Monitor
(2) Connect the diagnosis cable to data link
connector.
CAUTION:
Do not connect the scan tools except for Suba-
ru Select Monitor and OBD-II general scan tool.
5) Turn the ignition switch to ON (engine OFF) and
Subaru Select Monitor switch to ON.
ABS00111
6) On the «Main Menu» display screen, select the
{Each System Check} and press [YES] key.
7) On the «System Selection Menu» display
screen, select the {Brake Control System} and
press [YES] key.
8) Press the [YES] key after the {ABS} is displayed.
9) On the «ABS Diagnosis» display screen, select
the {Diagnostic Code(s) Display} and press [YES]
key.
10) On the «Diagnostic Code(s) Display» display
screen, select the {Current Diagnostic Code(s)} or
{History Diagnostic Code(s)} and press [YES] key.
NOTE:
• For detailed operation procedure, refer to the
ABS00112 "SUBARU
MANUAL".
• For detailed concerning the DTC, refer to the
LIST OF DIAGNOSTICS TROUBLE CODE (DTC).
<Ref. to ABS-25, List of Diagnostics Trouble Code
(DTC).>
• A maximum of 3 DTCs are displayed in order of
occurrence.
• If a particular DTC is not properly stored in mem-
ory (due to a drop in ABSCM&H/U power supply,
etc.) when a problem occurs, the DTC, followed by
a question mark "?", appears on the Subaru Select
Monitor display. This shows it may be an unreliable
reading.
ABS00113
ABS-18
(1) Power switch
SELECT MONITOR
(1)
ABS00114
OPERATION