Preparation; Attaching The Stand Unit - Sharp 60X50H Operation Manual

Preparation

Attaching the stand unit

• Before attaching (or detaching) the stand, unplug the AC power cord from the AC power outlet.
• Before performing work, spread cushioning over the surface on which you will be laying the TV. This will prevent it from
being damaged.
CAUTION
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over
Confi rm that there are screws with the stand unit.
1
Four big screws, four middle screws and
two long screws
(Big)
Attach the support angle for the stand unit
2
onto the base using the big screws with a
screwdriver as shown.
Support
angle
1 Insert the stand into the openings on the bottom
3
of the TV (hold the stand so it will not drop from
the edge of the base area).
2 Insert and tighten middle screws into the holes
on the rear of the TV.
Soft cushion
2
60X50H_en_ID5.indd 9 60X50H_en_ID5.indd 9
4
(Middle) (Long)
2
• To detach the stand unit, perform the steps in reverse order.
• A screwdriver is not supplied with this product.
1
2
1
1
Attaching the support cover.
1 Insert the support cover.
2 Insert and tighten long screws into the hole of
the support cover.
1
NOTE
.
2
9
2011-6-13 17:19:52 2011-6-13 17:19:52