Auto Power-Off After The End Of Broadcast; Auto Power-Off When There Are No Operations Performed; Picture Size Settings; Selecting The Wide Screen Signalling (Wss) Picture Size Automatically - Sharp 60X50H Operation Manual

Watching TV
Energy conservation settings (Continued)

Auto power-off after the end of broadcast

You can set the TV to automatically power off in about
15 minutes after the TV goes into a state of receiving
no programme signals, such as the end of a broadcast
day.
Press MENU and the MENU screen displays.
1
Press c/d to select "Setup".
2
Press b/c/d to select "ECO".
3
Press a/b to select "No signal off".
4
Press c/d to select "Enable".
5
• Five minutes before the power shuts down, the
remaining time displays every minute.
NOTE
• "Disable" is the factory preset value.
• When a TV programme fi nishes, and the TV receives signal
input, this function may not operate.
Auto power-off when there are no
operations performed
You can set the TV to automatically power off when no
TV operation is performed for 30 minutes or more than
3 hours.
Press MENU and the MENU screen displays.
1
Press c/d to select "Setup".
2
Press b/c/d to select "ECO".
3
Press a/b to select "No operation off", and
4
then press ENTER.
Press a/b to select "30 min." or "3 hr.".
5
• Five minutes before the power shuts down, the
remaining time displays every minute.
NOTE
• "Disable" is the factory preset value.
34
60X50H_en_ID5.indd 34 60X50H_en_ID5.indd 34

Picture size settings

Selecting the Wide Screen Signalling
(WSS) picture size automatically
WSS allows a television to switch automatically among
the different screen formats.
Press MENU and the MENU screen displays.
1
Press c/d to select "Setup".
2
Press b/c/d to select "Option".
3
Press a/b to select "WSS".
4
Press c/d to select "On" or "Off".
5
NOTE
• Try to set WIDE mode if an image does not switch to the
correct screen format. When the broadcast signal contains
no WSS information, the function will not work even if
enabled.
• This function is available for 3D images converted from 2D
images or normal 2D images.
Selecting the Wide Screen Signalling
(WSS) picture size manually
The WSS signal has 4:3 auto-switching that allows you
to select between Panorama and Normal.
Press MENU and the MENU screen displays.
1
Press c/d to select "Setup".
2
Press b/c/d to select "Option".
3
Press a/b to select "4:3 Mode", and then
4
press ENTER.
Press a/b to select "Panorama" or "Normal",
5
and then press ENTER.
WSS signal 4:3 screen
4:3 mode "Panorama"
Selected item
Panorama Wide image without side bars
Normal Normal range keeping 4:3 or 16:9 aspect
ratio
4:3 mode "Normal"
Description
2011-6-13 17:20:03 2011-6-13 17:20:03