Preparation; Attaching The Stand Unit - Sharp LC-80UD50H Operation Manual

Preparation

Attaching the stand unit

• When you attach the stand unit, put the TV on a flat surface.
• Before attaching (or detaching) the stand unit, unplug the AC power cord from the AC power outlet.
• Before performing work, spread cushioning over the surface on which you will be laying the TV. This will prevent it from being damaged.
CAUTION
• Attach the stand unit in the correct direction.
• Be sure to follow the instructions. Incorrect installation of the stand unit may result in the TV falling over.
Fit and secure base assembly
Place the TV on a flat surface with soft cushion
on top of it. Insert the stand unit into the slot
on the bottom of the TV while holding the
stand unit to avoid it falling over.
Soft cushion
"R"Stand
Insert the rest of four short screws into the
four holes on the back of the TV, and tighten
them.
Screws
NOTE
• When installing the stand unit, you need to put your TV on a
flat surface. Before that, put a soft cushion on the surface.
• To detach the stand unit, perform the steps in reverse
order.
• The angle of the stand unit is not adjustable.
• A screwdriver is not supplied with this product.
• During installation, please be careful to avoid getting your
hand trapped between the TV bottom and the floor.
"L"Stand
7