Control Panel - Fronius TransPocket 150 Operating Instructions Manual

Control panel

(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(8)
(7)
Setting value indicator
shows which setting value is selected:
- Arc-force dynamic
- Welding current
- SoftStart / HotStart function
- TIG pulsing (only with TIG version)
Unit indicator
shows the unit of the value that is currently being changed with the adjusting dial
(7):
- Time (seconds)
- Percent
- Frequency (Hertz)
Setting value button
for selecting the desired setting value (1)
Display
shows the current figure of the selected setting value
Welding process indicator
shows which welding process is selected:
- MMA welding
- MMA welding with Cel electrode
- TIG welding
Welding process button
for selecting the welding process
Adjusting dial
for continuous adjustment of the selected setting value (1)
Status indicators
display various operating modes of the power source:
- VRD - lights up when the safety device for voltage reduction is activated
- only with VRD devices
- Setup - lights up in Setup mode
- Temperature - lights up when the device is outside the permissible tem-
perature range
- Fault - lights up in the event of a fault, also see section "Troubleshooting"
- TAC - lights up when the tacking function is activated
(only on TIG devices during the TIG welding process)
(1)
(2)
(3)
(4)
(5)
(6)
23