Parameters For Tig Welding - Fronius TransPocket 150 Operating Instructions Manual

Parameter
Parameters for
Parameter
TIG welding
32
Description
Factory setting (FACtory)
This can be used to reset the device to its factory
settings.
- Cancel reset
- Reset the parameters for the selected weld-
ing process to their factory settings
- Reset the parameters for all welding process-
es to their factory settings
Resetting of the selected value to its factory set-
ting must be confirmed by pressing the adjusting
dial.
Level 2 Setup menu
For setting general parameters.
For details, see section
the level 2 Setup menu"
Description
Comfort Stop sensitivity (Comfort Stop Sensi-
tivity)
Factory setting: OFF
For details, see section
page 29.
Break voltage (U cut off)
Used to specify at which arc length the welding
process is completed.
The welding voltage increases as the length of the
arc increases. The arc is extinguished when it
reaches the voltage specified here.
This parameter is only available when the CSS
parameter is set to OFF.
Factory setting: 15 V
Factory setting (FACtory)
This can be used to reset the device to its factory
settings.
- Cancel reset
- Reset the parameters for the selected weld-
ing process to their factory settings
- Reset the parameters for all welding process-
es to their factory settings
Resetting of the selected value to its factory set-
ting must be confirmed by pressing the adjusting
dial.
Level 2 Setup menu
For setting general parameters.
For details, see section
the level 2 Setup menu"
"Welding parameters in
on page 33.
"TIG Comfort Stop" on
"Welding parameters in
on page 33.
Range Unit
no
YES
ALL
Range Unit
OFF V
0.3 - 2.0
12 - 30 V
no
YES
ALL