Carriage Motor Removal - Epson DFX-8500 Service Manual

DFX-8500

3.2.6.20 Carriage Motor Removal

1. Remove the left and right covers. (See Section 3.2.3.2.)
2. Remove the front panel. (See Section 3.2.3.3.)
3. Remove the upper case. (See Section 3.2.3.4.)
4. Remove the printer mechanism. (See Section 3.2.6.)
5. Remove the carriage motor fan. (See Section 3.2.6.19.)
6. Disconnect the red and black cables from the terminals on the carriage motor. There are two cables for
each terminal.
7. Remove 3 screws (CP (S), M4×10) securing the carriage motor to the right frame, then remove the
motor. (See Figure 3-77.)
Screw (CP (S), M4×10)
When you install the CR motor, perform the carriage timing belt tension and platen gap adjustments, as
described in Chapter 4.
3-54
Figure 3-77. Carriage Motor Removal
REQUIRED ADJUSTMENT
Carriage Motor