Stylus Color IIs / Stylus 820
3.2.6.6 Paper Feed Roller Unit Removal
1.
Remove the printer mechanism (see Section 3.2.5).
2.
Remove the carriage unit (see Section 3.2.6.1).
3.
Remove the carriage home position sensor (see Section 3.2.6.5).
4.
Remove the tension spring holding the tension roller assembly to the sub frame.
5.
Remove 2 CPS (M3x6) screws securing the front frame to the printer mechanism.
6.
Remove the paper feed roller unit.
Figure 3-15. Paper Feed Roller Unit Removal
3.2.6.7 Carriage Motor Removal
1.
Remove the printer mechanism (see Section 3.2.5).
2.
Remove the carriage unit (see Section 3.2.6.1).
3.
Remove the carriage (CR) motor.
Note:
When you remove the CR motor, be sure to keep the washer on the CR motor gear.
When you remove or remount the CR motor, be careful of the post at both the top and bottom of
the motor. If this post is broken, the motor will not seat correctly and can move during printing.
Rev. A
CPS(M3x6)
Front Frame
CAUTION
Figure 3-16. Carriage Motor Removal
Disassembly and Assembly
Paper Feed Roller Unit
Carriage Motor
Motor Holder
3-11