Removal Of Carriage Motor - Epson LX-810 Technical Manual

4.2.5.6 Removal of Carriage Motor

Perform Steps 1 to 5 of Section 4.2.5.4.
2. Disconnect the motor cable from the carriage motor. Disconnect the lead wire of the home-position
sensor from the molded clip at the bottom of the frame. (Refer to Figure 4-32.)
With a screwdriver, loosen the four tabs securing the carriage motor frame to the chassis frame.
Remove the carriage motor frame.
Carriage Motor Tabs
Connector
4!
Remove the belt tension spring from the carriage motor frame.
and timing belt.
'. Remove the carriage motor by moving it in the direction shown by the arrow above.
5
—... . . . . .
Figure 4-32. Carriage Motor Frame Removal
\
\ \,
Carriage
Motor
Figure 4-33. Removal of Carriage Motor
Remove the E-type (3.2) retaining
belt pulley shaft holder, belt pulley,
, Retaining E-Ring (3.2)
, Plain Washer
Belt
Pulley
Carnage Motor Frame
Belt Tension
Spring
4-22
Tabs
"f .
"
.'