Inserting The Batteries; Using The Buttons - Danfoss Eco Installation Manual

Installation Guide
Adapter for RTD valves (accessory)
1.
Place the RTD adapter on the valve as shown.
Adapters for M28 valves (accessories)
Please follow the instructions supplied with the valve adapter for the specific M28 valve.

1.5 Inserting the batteries

Remove the battery cover and insert two AA batteries. Make sure the
batteries are correctly oriented.
Rechargeable batteries must not be used.
When replacing batteries the programme settings will be preserved,
but after two minutes the settings for time and date are reset.
The low battery symbol
batteries run out.
After approx. two weeks the
to 21:00 hrs.
Before the batteries run out eco will leave the valve in Frost Protection
position to protect the heating system from damage.

1.6 Using the buttons

eco has two arrow buttons
and the menus and to set the temperature.
The middle button
If the display is off, press either button to activate the display.
Danfoss Heating Solutions
is displayed approx. one month before the
symbol will flash 14 times from 19:00
which allow you to navigate the display
is used to select and confirm.
eco Intelligent Radiator Thermostat
2.
Hand-tighten the RTD adapter (max. 5 Nm).
VIJPD102
7
06/2015