Temperature And Programme Settings; Setting The Comfort Temperature - Danfoss Eco Installation Manual

User Guide

4. Temperature and programme settings

4.1 Setting the comfort temperature

1.
If the display is off, press
Use the buttons to raise or lower the comfort
temperature (default temperature 21 ° C). eco
will maintain the new comfort temperature
until the next setback or comfort period.
3.
If the comfort temperature is set at its lowest,
the MIN and temperature show, indicating the
minimum constant temperature.
Note! If the set temperature is raised more than 1 °C eco will boost the radiator heat to reach the new
temperature faster. You can feel the valve and radiator are getting warmer.
Minor temperature changes will not evoke a heat boost, and so the changes are made without any
immediate indication.
16 06/2015
eco Intelligent Radiator Thermostat
.
VIJPD102
2.
If the temperature is changed during a setback
period (default 17 ° C), the new temperature
will only be valid for this setback period.
For a permanent change of the setback tem-
perature, see chapter 4.3.
4.
eco is measuring the temperature with two
built-in sensors - one behind the display and
one near the valve.
Based on both readings the room tempera-
ture is calculated for an area approx. 20 cm in
front of the display. This allows eco to control
the actual room temperature very accurately.
Be aware that sources of cold or heat, e.g.
fireplace, direct sun or draft, might affect the
function of eco.
Danfoss Heating Solutions