Troubleshooting - Siemens HB36D.75. Instruction Manual

Attaching the rail
Position the rail so that the indentations are facing upwards.
1.
Hook the rail in at the back and push it towards the rear until
2.
it engages (fig. C).
Hook the front of the rail onto the holder and press down until
3.
it engages and is fixed level in place in the appliance once
more (fig. D).

Troubleshooting

Malfunctions often have simple explanations. Please read the
following instructions before calling the after-sales service.
Repairs may only be carried out by fully trained after-sales
service technicians. Incorrect repairs to your appliance may
present considerable risks for the user.
Problem
The appliance does not work
The appliance cannot be started
The appliance cannot be started, the dis-
play shows
"Continue operation with 'Start'"
"Descale"
The appliance cannot be started, the dis-
play shows
"Continue operation with 'Start'"
"Clean"
"Clock" appears in the display
The appliance is not in operation. A cook-
ing time is shown in the display.
"Automatic switch-off" appears in the dis-
play
"Fill water tank" appears even though the
water tank is full
"Fill water tank" appears even though the
water tank is not yet empty, or "Fill water
tank" does not appear even though the
water tank is empty
The water tank empties for no discernible
reason. The evaporator dish is overflowing
24
&
Each set of rails only fits on one side.
:
Work on the appliance electronics may only be performed by
■
a specialist.
Always disconnect the appliance from the power supply
■
when work is carried out on the electronics. Switch off the
circuit breaker or remove the fuse from your household fuse
box.
Possible cause
The plug is not plugged into the mains.
Power cut
Fuse defective
Faulty operation
The appliance door is not fully closed
Descaling has been cancelled
The cleaning aid has been cancelled
Power cut
The rotary selector was accidentally oper-
ated
The Start button was not pressed after the
setting had been made.
The Automatic switch-off is active.
The water tank has not been pushed in
properly
The detection system is not working
The water tank is dirty. The mobile water
level indicators are jammed
The water tank was not closed properly
The tank lid seal is dirty
The seal in the tank cover is defective
Risk of electric shock!
Notes/remedy
Connect the appliance to the electricity
supply
Check whether other kitchen appliances
are working
Check in the fuse box to make sure that
the fuse for the appliance is OK
Switch the appliance off using the fuse in
the fuse box. Wait approximately 10 sec-
onds and then switch it back on.
Close the appliance door.
Press the Start button. Then rinse the
appliance twice (see section: Descaling.
Proceed as described under "Emptying
the evaporator dish and refilling the water
tank")
Press the Start button. Then rinse the
appliance twice (see section: Cleaning aid.
Proceed as described under "Emptying
the evaporator dish and wiping out the
appliance")
Reset the clock
(see section: Time-setting options)
Press the Stop button
Press the Start button or delete the setting
with the Stop button
Press any button.
Slide in the water tank until it engages
Call the after-sales service
Shake and clean the water tank. If the
parts cannot be released, obtain a new
water tank from the after-sales service.
Close the lid until you feel it engage.
Clean the seal
Obtain a new water tank from the after-
sales service
'