How To Change The Oxygen Sensor - Perkins 4016-E61TRS User Handbook Manual

4
4016-E61TRS

How to change the oxygen sensor

1 Disconnect the multi-pin plug (A1) on the oxygen sensor power cable from the connector on the oxygen
sensor interface (A2).
2 Remove the oxygen sensor (A3) from the turbocharger outlet.
3 Fit the new oxygen sensor into the turbocharger outlet tighten it down to 25 Nm (18 lbf ft).
4 Reconnect the multi pin plug (A1).
Note: Calibration of the EMS system will be required when the oxygen sensor is changed. Refer to the
Diagnostic Manual (TSL 4233).
User's Handbook, TSL 4230, Issue 4 33
This document has been printed from SPI². Not for Resale