Cleaning And Maintenance Guide - Christie DS+5K User Manual

Section 4: Maintenance
4.2 Cleaning and
Maintenance
Guide
4-4
Always power down and unplug the projector before
Table 4.1. Maintenance Guide
Part Description
Lens
Lamp
Filters
Covers (External)
WARNING
cleaning or servicing.
Frequency
CLEAN: Clean if absolutely necessary. A
As required
small amount of dust on the lens has very
little affect on picture quality.
To clean: Apply a solvent such as acetone,
alcohol or vinegar sparingly to clean, lint-
free lens tissue. Wipe across the surface of
the lens. Do not scrub or rub tissue in
circular motion, this will scratch the lens.
Do not reuse tissue. Do not use cleaning
tools treated with Ether. If particles still
appear on the lens, try using compressed air
to remove.
CLEAN: Clean if absolutely necessary.
Never touch the glass surface of the lamp.
Fingerprints left on the glass will seriously
degrade lamp performance or cause
"hotspots" which can lead to an
As required accumulation of intense heat in the touched
area and cause the lamp to shatter.
To clean: Wait until lamp is cool. Moisten
a clean, lint-free cotton cloth with isopropyl
alcohol and gently rub the surface of the
glass in a circular motion until clean.
1000 hrs or sooner REPLACE: Refer to 4.4 Lamp and Filter
if required
Replacement procedure later in this section.
REPLACE: Do not reuse old filters. Use
Whenever a lamp is
replaced or sooner the filter provided in the Christie Lamp and
if required
Filter Kit.
CLEAN: Clean dust from external covers
As required
using a clean, lint free cotton cloth as
required. NOTE: Before cleaning the
modules, it is recommended that you install
the lens cap. This will keep dust particles
from settling on the glass surface of the
lens.
User's Manual
Action