Cleaning And Maintenance Guide - Christie DS+6K User Manual

Hide thumbs Also See for DS+6K:
Table of Contents

Advertisement

Section 4: Maintenance
4.2
Cleaning and
Maintenance
Guide
4-4
Table 4.1. Maintenance Guide
Part Description
Lens
Lamp
Filters
Covers (External)
Proper face shield and protective gloves are required if
the lamp module is removed from the projector.
Frequency
As required
Clean the lens only when absolutely
necessary. A small amount of dust on the
lens has very little effect on picture quality.
To clean: Use a soft lint-free cloth without
any chemicals. Use only a high-quality
coated optics cleaning fluid, which can be
purchased from most camera supply stores.
Apply the coated optics fluid directly onto
the lint-free cloth until moistened. Wipe in a
single sweep across the surface of the lens.
To avoid scratching the lens do not scrub or
rub in a circular motion. Discard the cloth
after every use. Do not use cleaning tools
treated with Ether. Do not use cleaning
solvents that contain ammonia. Use
compressed air to remove any particles
remaining on the lens.
CLEAN: Clean if absolutely necessary.
Never touch the glass surface of the lamp.
Fingerprints left on the glass will seriously
degrade lamp performance or cause
"hotspots" which can lead to an
As required
accumulation of intense heat in the touched
area and cause the lamp to shatter.
To clean: Wait until lamp is cool. Moisten a
clean, lint-free cotton cloth with isopropyl
alcohol and gently rub the surface of the
glass in a circular motion until clean.
1000 hrs or sooner
REPLACE: Refer to 4.4 Lamp and Filter
if required
Replacement procedure later in this section.
Whenever a lamp is
REPLACE: Do not reuse old filters. Use the
replaced or sooner
filter provided in the Christie Lamp and
if required
Filter Kit.
As required
CLEAN: Clean dust from external covers
using a clean, lint free cotton cloth as
required.
NOTE: Before cleaning the modules, it is
recommended that you install the lens cap.
This will keep dust particles from settling on
the glass surface of the lens.
WARNING
Action
020-100001-01 Rev. 01 (04/07)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents