Christie DS+5K User Manual page 42

Section 3: Operation
What Channels
Are Defined So Far?
3-16
'
All available channels are listed in the Channel Setup menu, which describes how
each channel can be accessed and which serves as the gateway for editing, copying
and deleting channels.
From the presentation
level press Menu to display
the Main menu. To
display the Channel Setup
3
menu, press , or
move the highlight to the
Channel Setup option and
press . The Channel
Setup menu will appear
(see sample at right), with
the active channel highlighted.
WHAT APPEARS IN CHANNEL SETUP MENU?
lists all channels defined so far and indicates where they
are connected on the input panel. The far left column lists
channel numbers currently defined. The values in the far
right columns indicate horizontal and vertical
frequencies—if someone has defined a name for this channel, it appears here instead.
Remaining columns contain details pertaining to each channel setup, such as its
switcher number (always 0 = projector), slot location, a variety of icons indicating
access to each channel, and an abbreviated description of each signal type. See Editing
a Channel Setup for details.
NOTE: If you have more than a handful of channels, use
remaining channels not visible in the initial display of channels.
SIGNAL TYPE —
Either channel list, whether the
menu, identifies signal types in a shortened form as defined below. These descriptors
indicate what signal information the projector uses to identify a match for a given
channel, and are preceded by either an "i" (interlaced signals) or "p" (progressive
signal"). See Table 3.2.
Table 3.2. Abbreviations for Signal Type
Abbrev.
4WH
4WV
SG
5W
5WR
SVid
CVid
Dig
Figure 3.9. All Channels Appear in the
Channel Setup Menu
This menu
Channel
Signal Type
Composite (4 wire) on HC input
Composite (4 wire) on V input
Sync-on-green
Separate H,V
Separate H,V swapped
S-Vid
Composite Video
Digital
User's Manual
and to see the
key list or the Channel Setup