Hot-Plug Power Supplies; Removing A Hot-Plug Power Supply - HP ProLiant BL e-Class System Maintenance And Service Manual

Hot-Plug Power Supplies

IMPORTANT: You can use the Integrated Administrator to identify a failed power supply. Refer to the
HP ProLiant BL e-Class Integrated Administrator User Guide for details.
To remove a redundant hot-plug power supply:
1. Disconnect the power cord from the AC power source.
2. Disconnect the power cord from the hot-plug power supply.
3. Press the port-colored release button (1).
4. Open the hot-plug power supply handle (2).
5. Pull the hot-plug power supply out of the enclosure (3).
Figure 2-1: Removing a hot-plug power supply
Reverse steps 1 through 5 to replace the hot-plug power supply.
HP ProLiant BL e-Class System Maintenance and Service Guide
HP CONFIDENTIAL Codename: Kerr Part Number: 249066-004 Last Saved On: 5/12/03 3:00 PM
CAUTION: To avoid a thermal event, do not remove a failed power supply until a replacement
power supply is available.
Removal and Replacement Procedures
2-5