Table of Contents
Advertisement
40 www.aeg.com
3.
Put clean water (100 - 200 ml) into
the water drawer to flush the steam
generation system.
4.
Remove the water from the steam
generator with the sponge and rub it
dry.
5.
Keep the door open to let the appli-
ance dry fully.
12.4 Lamp
WARNING!
There is a risk of electrical shock.
The lamp and the lamp glass
cover can be hot.
Before you change the lamp:
• Deactivate the appliance.
• Remove the fuses from the fuse box or
deactivate the circuit breaker.
CAUTION!
Put a cloth on the bottom of the
interior of the appliance. It pre-
vents damage to the lamp glass
cover and the cavity.
Always use the same lamp type.
Replacing the lamp at the cavity
ceiling:
1.
Turn the lamp glass cover counter-
clockwise to remove it.
A
45°
2.
Remove the metal ring and clean the
glass cover.
3.
Replace the lamp with a suitable 300
°C heat-resistant lamp.
4.
Attach the metal ring to the glass
cover.
5.
Install the glass cover.
Replacing the lamp on the left side of
the cavity:
1.
Remove the left shelf support.
2.
Use a Torx 20 screwdriver to remove
the cover.
3.
Remove and clean the metal frame
and the seal.
4.
Replace the lamp with a suitable 300
°C heat-resistant lamp.
5.
Install the metal frame and the seal.
Tighten the screws.
6.
Install the left shelf support.
12.5 Door and glass panels
Remove the door to clean it.
Removing the door
CAUTION!
Be careful when you remove the
door from the appliance. The
door is heavy.
1.
Open the door as far as it goes.
A
2.
Fully lift up the clamping levers (A)
on the two door hinges.
3.
Close the door until it is at an angle
of approximately 45°.
4.
Hold the door with one hand on
each side and pull it away from the
appliance at an upwards angle.
Put the door with the outer side
down on a soft and level surface
to prevent scratches.
5.
At this time you can remove the in-
ner glass panels and clean them.
To install the door do the above steps in
the opposite sequence.
Advertisement
Table of Contents
