Manual Channel Search - Kathrein UFS 925 Operating Instructions Manual

After calling up the menu, you will see the
following on-screen display:

The buttons allow you to select
the parameters you want to change for the
search.
Satellite

Use the buttons to select the satellite on which the transponder you want to scan is located. By

pressing the button at this point, you can view a list of the installed satellites. Use the
to select the satellite you want and confi rm with the
aligned to this/these satellite(s). If you want to search several transponders on one satellite, you should
start an automatic search of the transmitting satellite.
Transponder frequency

Use the buttons (transponder frequency already saved) or the number pad (transponder
frequency not yet saved) to select the transponder frequency on which the channel being sought
is transmitted. By pressing the
for the selected satellite. Use the

button. At the bottom right of the screen display, the receiver shows the current signal strength
and signal quality of the selected transponder.
The "DVB type", "FEC", "Polarisation" and "Symbol Rate" options only need to be specifi ed if
the transponder has yet to be stored.
DVB type

Use the buttons to select whether you want to search for standard channels (DVB-S (SD)) or for
HDTV channels (DVB-S2 (HDTV)).
Main menu - Search Channels

Manual Channel Search


button at this point, you can view a list of the transponders stored

buttons to select the desired transponder and confi rm with the

button. Make sure your reception system is

buttons
95